Photo album - E. Matthys
This photo album is under construction. Thanks for your
patience.
Campus
Aerial view of campus (244K)
Non-Newtonian Fluid Mechanics and Heat Transfer
Non-Newtonian Fluid Mechanics and Heat Transfer Laboratory: a partial view (110K)
Non-Newtonian Fluid Mechanics and Heat Transfer Laboratory: heat transfer development setup (140K)
Test loops for study of the Fluid mechanics and heat transfer behavior of drag-reducing fluids (324K)
Modular loop setup for study of the Fluid mechanics and heat transfer behavior of drag-reducing fluids (60K)
Flow rate setup for study of the Fluid mechanics and heat transfer behavior of drag-reducing fluids (69K)
Main pumps used in field test of drag-reducing additives (297K)
Chiller used for field test of drag-reducing additives (250K)
Cooling tower and pumps in hydronic system used for field test of drag-reducing additives (331K)
DSR rheometer (F. Lange) for non-Newtonian fluid characterization (227K)
Others are an RMS800, an ARES, and several custom-built units
RMS-800 rheometer for non-Newtonian fluid characterization(43K)
Others are a DSR, an ARES, and several custom-built units
Dynamic light scattering setup for non-Newtonian fluid characterization (45K)
Birefringence cell for non-Newtonian fluid characterization (52K)
Materials Processing and Manufacturing
Levitator units for investigation of rapid solidification, spray deposition, and thermal contact - Materials Processing Laboratory (269K)
Close up of levitator coil - MPL (220K)
Drop impact setup - MPL (47K)
Melt-spinner for manufacturing and materials processing research - MPL(238K)
2-roll melt-spinner and spray gun for manufacturing research - MPL (248K)
Substrate spalling due to molten metal drop impact (61K)
[E. Matthys' homepage][Mechanical Engineering Department]
[College of Engineering]
[UCSB] [UCSB Web Sites]
For problems with- or comments about- this Web page, please contact
matthys@engineering.ucsb.edu
. Thank you !